This positioning system custom-built by Air Center will virtually eliminate rework. The setup is fully customizable for any tool, bit, bit trays, cables, and controllers.

The effector laser positioning system will only allow the tool to operate if it is in the correct position and the proper sequence. This eliminates missed torques and torquing the same item multiple times. Our torque system will display a green or red light for proper and improper torques. If the item has not been properly fastened the tool will not be able to move onto the next job.

A home position can be installed into the package. This will allow the tool to move off the line after the job is completed and indicate to the master controller that the line can proceed. For our positioning system we are using a Stanley tool and controller, an aeromatic balancer and a Doga tool holder and controller. For additional information and quotes Click Here.